Description
Suitable to empty ballast tanks,bilge wells,etc.in emergency cases often used for draining cargo and after the washing procedure.especially preferred where an electric spark may risk ignition or explosion .air pressure is 0.59MPa(6kgf/cm2)
Technical Bulletin
Pneumatic Sump Pump
Suitable to empty ballast tanks,bilge wells, emergency cases often used for draining cargo and after the washing procedure.especially preferred where an electric spark may risk ignition or explosion .air pressure is 0.59MPa(6kgf/cm2)
Operating and Safety precautions
Warning
This manual must be read and the operating instructions carefully followed.
Warning
Operators under eighteen not allowed to operate this pump.operators must be made familiar with the instructions i this manual before attempting to operate the pump.
Caution
Use only genuine teryair approved accessories.
Caution
Completely turn off the pump and disconnect the air supply line before attempting any service. Read assembly and disassembly instructions.
Caution
A regular maintenance after every 500 hours of operations will greatly add to the durability of the pump.
Warning
Take care not to exceed the maximum 7 bar (100psi) supply air pressure. Use a filter and regulator and lubricator as close to the pump inlet s operation will allow ensuring a clean and regulated and lubricated air flow.
Caution
Keep hoses in good condition. Check hoses for signs of wear,cracks and bulges and ensure that they are secure.accidental disconnection while hose is pressurized makes the hose whip and can be a safety hazard.
Caution
Please check the hose connection before starting the pump.
Store these pumpkin secure and dry environments .
Do not allow the pump to run unattended.
Do not modify this pump in any way as this will invalidate the warranty and could lead to serious injury.
Intended use:
STROKE Pneumatic submersible pumps are intended or use de-watering,transfer of fluids such as clear and sea water. Marine emptying of ballast tanks,damming cargo holds and pumping and sea water from bilges and holds.
It is a single stage centrifugal and driven by a powerful vane motor. Also double seals protect the bearing and motor from water and mud, and integral oilers provide continuous lubrication. Follow the instructions mentioned here to enhance the life and performance of the pump.
Operating instructions
Sump pump is rugged dependable equipment designed to give you years of satisfactory service. Follow the instructions mentioned here to enhance life and performance of your pump.
DAILY BEFORE OPERATING:
Disconnect and pour in 1to 2 ounces of recommended oil into the pump and reconnect the hose after blowing out any accumulated dirt in the hose line before connection.
LUBRICATION REQUIREMENTS:
Always install a line lubricator on the air line as close to the pump as possible.A filter regulator lubricator unit (FRL)is strongly recommended. Keep the lubricator bowl topped up with the recommended grade of oil and check that the oil is reaching the pump. Running the pump without lubrication is likely to cause damage to the components causing premature replacement.
AIR SUPPLY:
The pump works best at 6.2 bar (90 psi) air pressure. The air should be clean, dry, lubricated.install a FRL Unit as close as operation will permit.
HOSES:
Daily before operation check the hoses,especially the high pressure hoses for damage or leaks.
Use genuine teryair spares and if possible mention the serial number of the pump when ordering spares.
RECOMMENDED LUBRICANTS
